One of those things where there is no good solution, except ordering a new cable... because Wacom decided to permanently attach a multi-cable to the monitor, and (poorly) shrink-sleeved / molded a cable splitter.
Hopefully this little piece will protect that cable from further wear and tear. Re-molding would have been better, but I don't have the tools for that.
I printed the prototype in PETG, but didn't like the looks of it, so settled for ABS. (In hindsight I should have gone for PETG V0, not for flammability, but because it looks like ABS, but is just easier to handle and is less subject to layer delamination. Oh well. Next time.)
This little box 'clamps' the cables, in the hope that will avoid further damage.
No comments:
Post a Comment